Thingiverse
SD Card Tray
von sroyalty
7
Downloads
5
Likes
0
Makes
Tray for storing SD Cards. There is a 10 card and 20 card model.
As with my NVME tray, recommend 100% infill and if you get artifacts in the slots just slow the speed or clean it out post print.
v3 - Same as v1 but 1mm less for width for a tighter fit on the cards
v4 - Same as v2 but 1mm less for width for a tighter fit on the cards
As with my NVME tray, recommend 100% infill and if you get artifacts in the slots just slow the speed or clean it out post print.
v3 - Same as v1 but 1mm less for width for a tighter fit on the cards
v4 - Same as v2 but 1mm less for width for a tighter fit on the cards
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
