SD to SATA adapter case

This is a housing for a commonly available SD card to SATA adapter. For reference it is the model found here:
https://www.newegg.com/Product/Product.aspx?Item=9SIABR04YT8633&cm_re=sata_sdhc_adapter-_-9SIABR04YT8633-_-Product
or
https://www.amazon.com/gp/product/B0078PVL8U/ref=s9u_simh_gw_i2
or any number of ebay sellers. The board is about 50x75 mm.

You need two 3mm screws to hold it together. I used 3x8mm but any length of 5 to 10mm will probably work. The screws will just self-thread into the body.

The photo shows the Body and the Top pieces which was all I needed. In the unlikely event anyone else finds this part useful but wants to mount it in place of a 2.5 inch drive, I added an alternate part which provides for that. I haven't printed that part, but I am confident that it will work. It is designed to the 2.5 drive spec, including the position of the sata connector relative to the mount points *in the long direction*. In the lateral direction the connector is center