Thingiverse
SD2IEC 3 Button Replacement
1
Downloads
1
Likes
0
Makes
I had to open up my sd2iec and I lost the plastic piece that pushes the 3 buttons. I made this part to replace the OEM part.
I printed on PLA at 200/60. You need to clip off some original plastic on the inside of the case to make room for the flat part to fit snugly.
I printed on PLA at 200/60. You need to clip off some original plastic on the inside of the case to make room for the flat part to fit snugly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!