Thingiverse
sdcardholder
von STEM87_TEAM
0
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lVAWBLpGeKO
BE attention that the bolt is a little bit narrow than the hole.
At first, I make the bolt and the hole in the same dimension as 4m in diameter however the final result is too tight, I have to sand it down a little bit with sandpaper, so i change the dimension of the bolt a little smaller.
BE attention that the bolt is a little bit narrow than the hole.
At first, I make the bolt and the hole in the same dimension as 4m in diameter however the final result is too tight, I have to sand it down a little bit with sandpaper, so i change the dimension of the bolt a little smaller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!