Seed Spinner 120

This is a remix of the excellent 100 Pixel Spinner for seed pixels. In order to use commonly available seeds with 4" (10cm) spacing, I added one pixel to each leg segment, making a total of 12 pixels per leg (or 120 total seed pixels). The assembly instructions are the same as the original; I used #16 solvent cement plus screws to make sure the parts would stay together. Inserting the seeds into the back of the seed holders can be a bit tricky; I found that using a deburring tool (a must in my 3D print toolbox) to enlarge the holes a bit before assembling the spinner helps a lot. In xLights I used the native Spinner model; I attached a screenshot of my xLights settings and the export of my wiring view for your use here. My print settings are below; the inner and outer legs do not need supports, but the hub will benefit from them. The hub attaches to 1/2" PVC, but the fit may be a bit tight.

Print Settings
Printer brand:
Creality

Printer:
Hi Combo

Rafts:
No

Supports:
Yes