Slicer Discord
SeedPot – 3D-Druckmodell von Thingiverse Thingiverse

SeedPot

19 Downloads
16 Likes
0 Makes
Zum Modell
A little two piece planter I designed to help facilitate the movement of seedlings into larger planters for better root development. Plenty of holes on the inner ring for proper drainage and larger holes in the outer planter to assist. When the seedlings are ready to be moved, simply allow the soil to dry just a little so that it pulls away from the inner ring a bit, remove the outer ring and sit the plant into the transplanting container, preferably with a lining of mycorrhizae, then gently push the seedling down while pulling the ring up to plant perfectly, then backfill for support. If used properly, transplants are a breeze. It is very important that the seedling is removed before it grows through the pot, to minimize damage during transplanting. the whole idea is to get it out of this pot easily, excessive growth defeats the purpose of this pot. Good luck and happy gardening. Stay Kind.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen