Thingiverse
SeeedStudio Odyssey Stand
by alump
4
Downloads
3
Likes
0
Makes
Just a simple stand to give some protection to your Seeedstudio Odyssey SBC. Will leave 1cm space between the base surface and the heatsink - hopefully improving cooling and preventing heatsink scratching the surfaces.
Printed this in PETG, just incase it gets little warm. But most likely PLA would be also totally fine. When printed upside down, no supports needed.
M3x6x5mm threaded brass inserts fit all 5 holes. 4 corners holes also fit M3x8x5mm. If you don't push the inserts all the way in, those keep the board little off the frame.
If I get bored again, might add modularity to this. It would be nice to have an optional side panel where to attach RP-SMA antennas.
Printed this in PETG, just incase it gets little warm. But most likely PLA would be also totally fine. When printed upside down, no supports needed.
M3x6x5mm threaded brass inserts fit all 5 holes. 4 corners holes also fit M3x8x5mm. If you don't push the inserts all the way in, those keep the board little off the frame.
If I get bored again, might add modularity to this. It would be nice to have an optional side panel where to attach RP-SMA antennas.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!