Thingiverse
Seeker HS underbone Camera mount and protector
von Moose_Josh
1
Downloads
1
Likes
0
Makes
I printed with 2mm thick walls and base with support.
The 30 degree has a MINIMUM angle of 30 degrees and the 45 is also a MINIMUM angle.
If you would like a lower angle just let me know and i'll edit the drawing.
+ Added a 20 degree version just in case.
The 30 degree has a MINIMUM angle of 30 degrees and the 45 is also a MINIMUM angle.
If you would like a lower angle just let me know and i'll edit the drawing.
+ Added a 20 degree version just in case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!