Sega megadrive USB-C mod

I created this version because the adapters I found sit too deep inside the shell, preventing the USB cable head from fitting through the hole. In this model, the female USB-C sits flush with the shell, so there are no issues with any cable. The printed part replaces the original PCB. I glued the connector to the printed part using a bit of hot glue. It might not be the best connector for this mod, but it was the one I had at home from other projects. With a layer height of 0.16 and the supports set as I uploaded in the profile, I don't have any tolerance issues with PLA Basic. I cannot increase the tolerance in X because it’s already at the limit of the housing's hole diameter. Link to the USB-C connector I used (green model with resistors): https://es.aliexpress.com/item/1005012008083825.html?spm=a2g0o.order_list.order_list_main.5.5a6c194dVkdo6w&gatewayAdapt=glo2esp Link to the tutorial that I used to perform the mod: https://retrosix.wiki/wiki/cleanpower-usb-c-mega-drive If you have