Slicer Discord
Self resetting mouse trap – 3D-printbaar model van Thingiverse Thingiverse

Self resetting mouse trap

46 Downloads
22 Likes
0 Makes
Model downloaden
use this with a 5 gallon bucket, peanut butter and rod to make a self resetting mouse trap
inside diameter is .1 inches kust under 3 mm if you need it bigger let me know and i will make it so
They are both the same diameter about 2.5 inches
the short one is 3 inches in length
the long one is 4 inches in length
there are also a collar to keep the trap in place on the rod
print 4 collars and use two to hold the trap and two to hold rod from falling off of bucket
for collar 6-32 you will need to buy #6-32 set screws
for collar metric you will need a 4mm-7 set screw
they are both available at home depot
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie