Self Watering Planter

This self watering plant prints in two parts, the part that holds water, and the part that holds the actual plant. To get it to work, you will need about 1 inch of shoelace, and you need to put it into the hole in the bottom of the part that holds the actual plant. Place the shoelace so about half of the shoelace is on the inside of the pot, and the other half of the shoelace is sticking out the outside. Next, fill the part that holds the actual plant with soil. Place it into the part that holds the water and fill it with water. The shoelace will slowly suck up water into the soil, and when the plant needs more, it will suck up more water. Needs a refill of water about once every 2 days, but the larger/smaller you scale up the print, timing will vary.