Thingiverse
Self-watering seed starter
door Kickin_Prints
835
Downloads
1.5k
Likes
2
Makes
Introducing the ultimate solution for hassle-free seed starting – a self-watering seed starter with 16 cups! Designed with convenience and efficiency in mind, this 3D-printed model is a game-changer for anyone looking to grow their own plants with minimal effort.
You will need to print the following:
1 Base
1 Lid
16 Cups – vase mode can be used for the cups (but you may not be able to print multiple at the same time)
16 Hole Covers
Instructions:
• Snap the lid onto the base
• Place one cup in each of the holes on the lid – there will be a few millimeters between the top of the base and the bottom of the cups
• Place one hole cover (flat side up) in each cup. This will allow the water into the cup while minimizing the amount of media/soil that gets into the water reservoir.
• Plant seeds
• Water – to avoid overwatering, the water level should not be above the depth of the seeds.
If scaling is needed to fit on your print bed, be sure to scale all pieces equally.
W
You will need to print the following:
1 Base
1 Lid
16 Cups – vase mode can be used for the cups (but you may not be able to print multiple at the same time)
16 Hole Covers
Instructions:
• Snap the lid onto the base
• Place one cup in each of the holes on the lid – there will be a few millimeters between the top of the base and the bottom of the cups
• Place one hole cover (flat side up) in each cup. This will allow the water into the cup while minimizing the amount of media/soil that gets into the water reservoir.
• Plant seeds
• Water – to avoid overwatering, the water level should not be above the depth of the seeds.
If scaling is needed to fit on your print bed, be sure to scale all pieces equally.
W
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!