Slicer Discord
Semi-Automatic Crossbow – Modèle 3D imprimable de Thingiverse Thingiverse

Semi-Automatic Crossbow

45 Téléchargements
38 Likes
0 Makes
Voir le modèle
I was a little underwhelmed with the miniature weapon selection on the site, so I spent a couple of hours working on this. Load the magazine up to ten shots, and it will fire one after another.
Tips:
Assemble with computer hard drive screws (you know, the smaller threaded ones)

Holes, for the most part, are all 10mm apart, very easy to make further attachments.

I really don't know why I have to explain it to everyone I hand this thing to, but here's how you fire it (properly).

1) Pinch your fingers around the firing pin
2) Pull the pin back quickly as to allow only a single pellet to enter the chamber. Doing this slowly (like scared you're gunna break it slowly) will sometimes either cause it to jam, or for some of the pellets to fall out.
3) You don't have to but to get the most powerful shot, pull the pin as far back as you can without it falling out of the chamber. (no really, someone pulled it back just enough for the pellet to load, and then complained that the shot
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
supports nécessaires
Monobloc Supports requis Visserie requise
Supports 2/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection