Semi-Posable Flexi Facehugger

**UPDATE**

A lot of folks have been, understandably, struggling with the ball joints - the tolerances are very fine. As such I have added single ball joint models for both finger and tail at 96% the original size, and 93% the original size. Print one of each and see which works best, and then print up the rest.

I have also added models for single left and right fingers to make it easier to reprint a single finger in case of hugger-related disasters.

I hope this helps!

--oOo--

I printed up OneIdMONstr's amazing flexi-facehugger, and was indeed amazed - it is a superb model. But it was a bit too floppy to be entirely intimidating. So, time for a little bit of a mechanical remix...!

I scaled the model up, smoothed it out a touch, and then sliced it up to add ball and socket joints at the end of the fingers and tail. I have the actual ball joints themselves printed separately and then slotted into holes in the body.

This is mainly a practical choice, my print