Sendstorm lite pods

i sliced with s3d, best to do 1 outline perimeter as it is a thin around the arch and this makes it the stiffest from the many pods i have printed. Printed at 1.6 layer height, make sure you have supports turned on.
i have been getting creative with slicer settings and changing them half way through print but in the end you can do what ever settings you want.

there is 3 designs one for runcam nano 2, locked at 45 degree, one for foxeer nano locked at 45 degree and one for both with changable angle. they are designed for singularity antenna. the holes are for putting a cable tie through to hold vtx to top of pod.
designed for 15mm stand off at the front and 25mm stand off at the back.
the pod weighs about 20grams when done. i do have a 15gm lighter version but requires someone that is good with slicer settings to make it print strong and stiff. just ask me if you want that version and i will send it.

i only make these for myself because it is the quad i run so i make them