Thingiverse
Sensor Case with Lid for LED Module (Keyestudio)
by HeliconOne
2
Downloads
1
Likes
0
Makes
This is a case for Keyestudio sensors/modules, 20x31 mm. This design is for LED-modules.
The lid has a snug fit and closes well. (The sensor/module is also with a snug fit but if you want to feel more secure you can add a small piece of dubble-sided tape on the underside of sensor/module.)
There are two versions for the lid: One with just a plain hole for the LED and another with a hole and "reflector".(The latter need supports to be printed properly.
The lid has a snug fit and closes well. (The sensor/module is also with a snug fit but if you want to feel more secure you can add a small piece of dubble-sided tape on the underside of sensor/module.)
There are two versions for the lid: One with just a plain hole for the LED and another with a hole and "reflector".(The latter need supports to be printed properly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!