Thingiverse
Sensor Mount cap for Customizable Bowden carriage
por Mchaos
7
Descargas
2
Likes
0
Makes
I tried a few sensor mounts out for my Anet. Unfortunately none of them seem to be the solution. So I went back to scratch.I used the v6 clamp area from the original cap that came with the customizable bowden carriage, but the rest was ground up. This is actually the second version. The first version, which is on my printer now, is too close to the hot end fan duct, and causes it to deflect outward, which can cause an issue with leveling. It works.. but it is ugly.. so I remade it once more and came up with this.
It works great. Sits perfect.
Here is the offset I am using and seems to be spot on:
X_PROBE_OFFSET_FROM_EXTRUDER 20
Y_PROBE_OFFSET_FROM_EXTRUDER 0
You could probably go back a couple of mm on the Y but that is working well for me.
It works great. Sits perfect.
Here is the offset I am using and seems to be spot on:
X_PROBE_OFFSET_FROM_EXTRUDER 20
Y_PROBE_OFFSET_FROM_EXTRUDER 0
You could probably go back a couple of mm on the Y but that is working well for me.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
