Serpent

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Grey Transmission Distance: 1PLA BambuLab Basic Ice Blue Transmission Distance: 3.5PLA BambuLab Basic White Transmission Distance: 5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to Blue GrayAt layer #14 (1.2mm) swap to GreyAt layer #19 (1.6mm) swap to Ice BlueAt layer #21 (1.76mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!