MakerWorld
Robotics
Go to Model
Servo Claw
137
Downloads
43
Likes
62
Makes
Instructions Insert a nut into the underside of the servobox (Middle) Fit the servobox over the microserver Attach the right pincer to the shaft with the servo accessories (it might be a good idea to screw it in place) Attach the left pincer with an M3 screw Printed with PETG; however, I doubt there would be any issues with PLA. You may be able to add rubber bands to improve the grip! Original model: https://www.thingiverse.com/thing:18339
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
