Servo Mount for Pi-Camera

There are two ways of assembling the lower part of the mount:
Using a bearing (W1) helps to stabilize the mounts rotation.

Way 1 (Picture 7 / 8):
-Glue a bearing of common size inside the shell
-Press the pin (Picture 8) in the bearing and check that the rotor of the servo motor
fits inside the opening on the pin
-Glue both shell and pin on the lower side of the mount body (Picture 6), make sure
that the rotation of the servo also transfers on the pins axe

Way 2 (Picture 9):
-Use the attached rotor adaptors of your servo to mount the whole gimbal on it (may
be unstable and rigid)

The cameras ribbon cable can be slid through the slot on the camera mount (Picture 5).

It can move on both axes up to ~180 degrees.