Servo robot frame

takes standard 360 servos. print nose up. extra support tor gopro mount on baok onyx 5000 lipo fits between motors.

questions or comments or suggestions? pop 'em in the comments

Update Jul 31:
i added version 3. version 3 is exactly the same except for a 1/16 inch thick support that bridges the corners on the servo wire cutout. i printed version 2 yesterday and the corners didn't print right because it was printing over air. the little supports will allow for a nicer end product. no support needed on print and print nose up. cut the little support out when print is done. I left version 2 just in case if someone wants it