Thingiverse
Seven Segment Digit
von minted52
3
Downloads
2
Likes
0
Makes
This is an OpenScad design I used to build a
seven-segment display based on a strip of
WS2811 RGB LEDs to illuminate digits of the
display. I soldered the individual WS2811s
to flexible wires, then drilled holes in the
printed part so that the entire thing was
just one chain going through all the digits.
seven-segment display based on a strip of
WS2811 RGB LEDs to illuminate digits of the
display. I soldered the individual WS2811s
to flexible wires, then drilled holes in the
printed part so that the entire thing was
just one chain going through all the digits.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!