Thingiverse
Sewing Box (Lasercut)
von ommtom
72
Downloads
120
Likes
0
Makes
A Sewing-Box made of plywood with lasercut.
Finally you have to drill the holes manually, but this gives the opportunity to tune the thing as it comes out of the lasercut process.
As always lasercut is done from the inside to the outside for all objects.
Screws are 4mm in diameter, I used countersunk screws 10mm long and flat nuts.
Have fun and post a make if you used this scheme.
Finally you have to drill the holes manually, but this gives the opportunity to tune the thing as it comes out of the lasercut process.
As always lasercut is done from the inside to the outside for all objects.
Screws are 4mm in diameter, I used countersunk screws 10mm long and flat nuts.
Have fun and post a make if you used this scheme.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
