Thingiverse
SF2 Divesoft Cell adaptor
2
Downloads
2
Likes
0
Makes
This Adaptor has been designed to use Oxygen Cell from SF-2 rebreather in the divesoft Analyser.
The rebreather cells have an additional membrane to protect from noisure, this leads that the cells are reacting slower than the cells which are originally used in the Analyser. Take your time to calibrate & measure!
"Old" Cells from rebreather can still be used in the analyser as current limiting is not that critical on surface pressure, calibration should be done with at least 2 points (Air & 100% O2)
-) Print adaptor & screw
-) Build adaptor cable
-) Put an O-ring (22x1.5) into the adaptor
-) Place original O-Ring from the old cell onto the adaptor thread.
It can also be used to use an SF-2 Cell in a rebreather with Cells which have the M16x1 thread, e.g. JJ.
! Only do that if you know what you do! Use at your own risk!
The rebreather cells have an additional membrane to protect from noisure, this leads that the cells are reacting slower than the cells which are originally used in the Analyser. Take your time to calibrate & measure!
"Old" Cells from rebreather can still be used in the analyser as current limiting is not that critical on surface pressure, calibration should be done with at least 2 points (Air & 100% O2)
-) Print adaptor & screw
-) Build adaptor cable
-) Put an O-ring (22x1.5) into the adaptor
-) Place original O-Ring from the old cell onto the adaptor thread.
It can also be used to use an SF-2 Cell in a rebreather with Cells which have the M16x1 thread, e.g. JJ.
! Only do that if you know what you do! Use at your own risk!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
