Thingiverse
Sg906 pro Battery holder
von 3DP-Skeleton
4
Downloads
6
Likes
0
Makes
This is a holder for up to 3 sg906 pro + Pro 2 battery's sg906 may not fit as they are a bit longer.
there is 0 supports needed in either orientation the pest way is to print the flat one and rotate it a little so that it doesn't lift up during print.
15% infill is most you will need.
there is 0 supports needed in either orientation the pest way is to print the flat one and rotate it a little so that it doesn't lift up during print.
15% infill is most you will need.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!