Slicer Discord
Shadow & Light Clock – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Shadow & Light Clock

von MaKim · Decor
35 Downloads
232 Likes
7 Makes
Zum Modell
This clock was an experiment to see if I could show the time by casting a shadow. When the power's off, the clock appears as a monolithic circle but the detail is revealed when the light is activated. This is a single-color print that would work well with any light-color filament that transmits light well - check the gallery to see it in orange, yellow and white marble. Printed PartsFront ShellBaseBack ShellMinute HandHour HandButton CoverStandAssembly InstructionsAttach the switch to the base with using (2) M2x6 screws - orient the port so that it's facing out with room to attach a wire.Feed the USB power cable through the rectangular space in the back of the back shell. This will be a tight fit and may require rotating the cable to find space.Attach the PH2.0 connector from the power cable to the Y connectorAttach the black wires of the Y connector to the switchAttach the red/black wire to the COB LED.Feed the LED through the hole in the base.Start at the end of the LED and p
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Marble PLA
Mindest-Druckbett
200 mm (Groß)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen