Thingiverse
shaka hands valve cap
door Dillyvl
0
Downloads
1
Likes
0
Makes
prints in just about any position, i had vreality slicer figure out what side gave most surface to the plate and printed like that. k1 max printed it in 47min in generic pla.
fit's any standard bike/car tire valve. it will thread on first use, trhread is not printed.
remixed from hand gestures, made a valve cap sized support, shortened the pinky (that was huuuuge) and played a bit with the dimensions to make it narrower and longer.
leave a like and build picture if you printed it
fit's any standard bike/car tire valve. it will thread on first use, trhread is not printed.
remixed from hand gestures, made a valve cap sized support, shortened the pinky (that was huuuuge) and played a bit with the dimensions to make it narrower and longer.
leave a like and build picture if you printed it
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!