Thingiverse
Shampoo holder
door hallonhatt
14
Downloads
31
Likes
0
Makes
A holder for two large (ø ~92mm ) shampoo and conditioner bottles to be squeezed onto two 12mm pipes.
When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)
When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)
hallonhatt publiceert ook op
19 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
