Thingiverse
Shapeoko bit catcher tray
von ex-nerd
21
Downloads
7
Likes
0
Makes
The Shapeoko moves out over the front of the machine for bit changes, which has led to more than a few bits falling to the ground and breaking. This little tray clips onto the front of the machine to catch any bits that might slip out of the collet and fall.
Designed to print at an angle so no supports are needed. Depending on how sticky your bed is, you may need a brim.
Designed to print at an angle so no supports are needed. Depending on how sticky your bed is, you may need a brim.
ex-nerd veröffentlicht auch auf
73 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
