Thingiverse
ShapeOko Clamp Set
door SmartBlug
187
Downloads
87
Likes
1
Makes
Same dimensions as the original one (https://www.inventables.com/technologies/clamp-set).
Just put a M5 nut inside and block with the small piece.
Screw with a M5 screw on your table (adapted with this http://www.thingiverse.com/thing:414443) and use a second M5 screw flipped in order to maintain at the right height.
This allows you to adjust the clamp so that is less likely to damage softer materials.
Use the nut if you want to tighten with your fingers.
Just put a M5 nut inside and block with the small piece.
Screw with a M5 screw on your table (adapted with this http://www.thingiverse.com/thing:414443) and use a second M5 screw flipped in order to maintain at the right height.
This allows you to adjust the clamp so that is less likely to damage softer materials.
Use the nut if you want to tighten with your fingers.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
