Slicer Discord
Shark pencil grip – 3D-printbaar model van MakerWorld MakerWorld
Gadgets

Shark pencil grip

door WarrenDz · Gadgets
445 Downloads
91 Likes
312 Makes
Model downloaden
I was trying to get my son excited about gripping his pencil properly, as opposed to from the very end, but wasn't having much luck. He's big into animals, especially sharks at the moment, so I modelled a grip and replaced the central ‘barrel’ that wrapped around the pencil with this incredible shark model by Geoffro. I modified the shark by straightening it out to align with a pencil, removing the smaller fins, elongating the torso, and adjusting the proportions to suit the application. The central hole through the shark is modelled with a 7.5mm internal diameter and should fit most pencils, but your mileage may vary depending on pencil dimensions. Feel free to experiment with scaling it to suit your writing utensils. Note: This prints with supports due to the orientation and it might take a little effort to free the finger holsters.
Categorie
Gadgets
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
supports nodig
Eendelig Supports vereist
Supports 2/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie