Thingiverse
Shark Vacuum Elbow Fitting
door MadMan604
0
Downloads
5
Likes
0
Makes
A part for Shark Navigator vacuum cleaner model NV352 31
May fit other Sharks.
This is the fitting that attaches to the body of the vacuum cleaner, the inlet to the dust bin. The elbow at the end of the hose fits in here. Mine broke and I like this little vac so I designed this. This is the second printable thing I designed myself. There is some minor airflow improvement over the factory piece. This should fit perfectly snug on the vacuum body, and I made the inner diameter just a bit larger to accommodate the hose elbow without this piece being stretched too much.
For installation, the vacuum body needs to be completely disassembled to access the two screws holding it, there is no shortcut.
May fit other Sharks.
This is the fitting that attaches to the body of the vacuum cleaner, the inlet to the dust bin. The elbow at the end of the hose fits in here. Mine broke and I like this little vac so I designed this. This is the second printable thing I designed myself. There is some minor airflow improvement over the factory piece. This should fit perfectly snug on the vacuum body, and I made the inner diameter just a bit larger to accommodate the hose elbow without this piece being stretched too much.
For installation, the vacuum body needs to be completely disassembled to access the two screws holding it, there is no shortcut.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!