Thingiverse
Sharpie Case
von Hurricanemcc
3
Downloads
5
Likes
0
Makes
Needed somewhere to store my Sharpie markers and but also provided easy access to each colour without too much clutter. Turned out better than expected.
Printing:
Printed on Ender 3 Using Creality Slicer. Used layer height of 0.2mm.
Fully assembled case is 88mm diameter and 175mm in height.
Printing:
Printed on Ender 3 Using Creality Slicer. Used layer height of 0.2mm.
Fully assembled case is 88mm diameter and 175mm in height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
