Thingiverse
Shelf End Cap and mount
by skelo
11
Downloads
8
Likes
0
Makes
ClosetMaid specific, but I guess could be reworked for top to bottom rail spacing.
I print a mirrored set so that I can use the bottom side (first layer) which is a the better finish in my opinion to show better for install.
You may have to make them a little thicker based on the space between the end of the shelf wall. I had some that were cut 1/2" short of the wall.
I print a mirrored set so that I can use the bottom side (first layer) which is a the better finish in my opinion to show better for install.
You may have to make them a little thicker based on the space between the end of the shelf wall. I had some that were cut 1/2" short of the wall.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!