Thingiverse
Shelf Mount
von tonystark4009
3
Downloads
1
Likes
0
Makes
A 1.5" wide and 3" long simple wall mount.
Minimum 10% Infill (Cubic pattern for best strength)
PLA 1.75mm, Bed 50C, Hot End Temp 208C
Needed a wall mount for my DSO, but can be used for anything.
Minimum 10% Infill (Cubic pattern for best strength)
PLA 1.75mm, Bed 50C, Hot End Temp 208C
Needed a wall mount for my DSO, but can be used for anything.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!