MakerWorld
Decor
Go to Model
Shelf
103
Downloads
53
Likes
47
Makes
a small 16x16 cm shelf that was to be used to hold surround speakers.printed in petg because they were going to hang by radiator.but PLA is fine too.no support needed added an extra file containing the screw hole which can be used to ensure that you can make 100% infill around the screw holes
mark also publishes on
92 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
