Shelf Reliance Pop Can Mod

This is a mod for the Shelf Reliance Pantry shelves designed to allow pop/soda cans to bge loaded on the shelf and roll properly. Due to the angle of the top of a pop can, they tend to not roll well. Also, the original spacers are either too tight and the cans wont roll at all or too loose and the cans fall through. You can put the original spacers at an angle to get them to work but you still have issues with the slope.

Print:
One each of the upper, lower, and curve pieces (PLA or ASA)
Four of the 160mm ramps (PLA or ASA)
Three of the spacers (ASA works better but PLA will work)