MakerWorld
Other House Models
Zum Modell
Shelf support for Ignis Fridge
24
Downloads
5
Likes
20
Makes
This was designed as a “replacement” part because the original bracket that held the shelf broke off on one corner. It doesn't replace the original one, but sits besides it.Works on our Ignis ARL 979, but might work on other fridges too. Measurements to check if it could work in your fridge, as seen when installed in the fridge: Width: 18.6mmLength: 30mmHeigth: 6.6mm Slot height (about your fridge's shelf thickness): 2.92mmSlot depth: 7.1mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
