Thingiverse
Electronics
Zum Modell
Shelly Dimmer Case
277
Downloads
107
Likes
1
Makes
Known Issues:
-The holes are 5mm and the pegs are 4mm, this is because my printer has loose tolerances. If you want the box to actually "snap" together, you'll need to increase the size of the pegs. I just used glue once it was all wired.
-There should probably be some strain relief on the L wire coming out of the dimmer.
-The holes are 5mm and the pegs are 4mm, this is because my printer has loose tolerances. If you want the box to actually "snap" together, you'll need to increase the size of the pegs. I just used glue once it was all wired.
-There should probably be some strain relief on the L wire coming out of the dimmer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
