MakerWorld
Electronics
Ver Modelo
shift knob for th8s(no adapter needed)
213
Descargas
48
Likes
114
Makes
So i modeled a shifter knob for thrustmasters new th8s shifter i noticed that there was none of these on the internet, i only found adapters and almost none shifters that fit on the adapters, so i decited to make my ownit just slots into the shifter slot and uses the original shifter knob screw, so there is no adapter neededthere are 3 files, 12mm one is the one with a big hole on the top for bigger screwdrivers and the 8mm for smaller ones, the screw just fits in so make sure the printer is calibrated, there is also one with no hole because it goes in very tightly on its own too good for people who dont have long torx screwdriversi made mine out of pla, petg would be stronger15% infill0.20mm qualityno supportsand a brim original post from my printables page: https://www.printables.com/model/698062-shift-knob-for-th8sno-adapter-needed/files
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!