Thingiverse
Shifter Knob
by richreibel
4
Downloads
0
Likes
0
Makes
A 51mm (2 inch) manual trans shift knob with a 3/8-16 thread. Looks and feels particularly nice if you print it using fuzzy surface mode in your slicer (as shown in the pic).
No supports needed and 10% infill is fine, but more will add strength and weight.
See the complete collection of my 3D print creations on Printables.com at:
https://www.printables.com/social/258622-rreibel/models
Enjoy!
No supports needed and 10% infill is fine, but more will add strength and weight.
See the complete collection of my 3D print creations on Printables.com at:
https://www.printables.com/social/258622-rreibel/models
Enjoy!
richreibel also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
