Slicer Discord
Shock Absorber Keytag – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

Shock Absorber Keytag

1.5k Downloads
898 Likes
610 Makes
Zum Modell
Awesome shock absorber keytag!This one might be a little tricky to assembleAll you need is printed parts, around 20,5cm of filament for spring, superglue, scalpel and a lighter Step 1:Glue together parts 2 and 4 (on the picture) Step 2:Make the piston rod as round as possible by cutting glued edges with scalpel Step 3: Use part 5 as filament bend guide. First heat a small part on one of the ends of 20,5cm piece of filament with lighter and put it on the guide tower (part 5). Heat up next parts of filament to make it bend around and after spring is cold, take it off the guide tower. Step 4:Put the spring on the piston rod (part 2 and 4) and put it in part 1. Use a little amount of glue on part 1 so it wont drip inside and put part 3 on part 1 to glue them together
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

mlodybuk veröffentlicht auch auf

56 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen