Thingiverse
Shock mount for Aston Origin
von The-explorer
6
Downloads
4
Likes
0
Makes
This is a simple but good microphone shock mount for Aston Origin.
Found a few designs here on Thingiverse but i couldn't find one that wasn't to big or it needed several screws and parts to assemble.
so i designed this out of what i found here and on the internet.
Inside dimensions for the microphone is 54mm and there is a 5/8 inch mounting for the microphone stand.
The string i used to assemble the 2 parts together was Arnitel® ID 2045 1.75mm. Its a TPC material with a Shore Hardness of 34D.
Any flexible filament will do as long as its soft.
I printed my parts in Ultem 9085, but any material will do.
Found a few designs here on Thingiverse but i couldn't find one that wasn't to big or it needed several screws and parts to assemble.
so i designed this out of what i found here and on the internet.
Inside dimensions for the microphone is 54mm and there is a 5/8 inch mounting for the microphone stand.
The string i used to assemble the 2 parts together was Arnitel® ID 2045 1.75mm. Its a TPC material with a Shore Hardness of 34D.
Any flexible filament will do as long as its soft.
I printed my parts in Ultem 9085, but any material will do.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
