Thingiverse
Shoe lift
por Jwessel
0
Descargas
0
Likes
0
Makes
This used to use on the opposite foot when using a moon boot to even out your gate.
Recommend 10% infill to keep the print light.
Recommend support only to the part that contacts the build plate.
Recommend PLA filament.
Use in conjunction with 400mm x 30mm Velcro straps.
Recommend a layer of adhesive non slip rubber to the bottom of the lift
Recommend 10% infill to keep the print light.
Recommend support only to the part that contacts the build plate.
Recommend PLA filament.
Use in conjunction with 400mm x 30mm Velcro straps.
Recommend a layer of adhesive non slip rubber to the bottom of the lift
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!