Thingiverse
Shoe rack
von jhkim41314
19
Downloads
20
Likes
0
Makes
Brackets for building your own shoe rack
Feet and spacer require supports everywhere. Bracket and topbracket do not need supports.
You will need 4 of each parts (Total of 16 printed parts) to build a shoe rack with 2 rows.
You can add another row by printing 4 of spacer and bracket.
Will need #8 x 3/4" wood screws and 1/4-20 x 1.25" bolt and nuts for assembly
Use 1" thick boards for the rack (I used edge-glued pine boards from Menards link: https://bit.ly/2lJbnhg)
This print is not recommended for most people as it takes a long time for print and will require a lot of filaments. The sizes of brackets are also overkill for shoes as I was able to stand on the rack. It will be a lot cheaper to just purchase one from Walmart or Ikea.
I still need to print the feet, but the rest of the parts fit well without any issue.
Update 7/2/2018
I finished printing and I can confirm that everything fits nicely.
Feet and spacer require supports everywhere. Bracket and topbracket do not need supports.
You will need 4 of each parts (Total of 16 printed parts) to build a shoe rack with 2 rows.
You can add another row by printing 4 of spacer and bracket.
Will need #8 x 3/4" wood screws and 1/4-20 x 1.25" bolt and nuts for assembly
Use 1" thick boards for the rack (I used edge-glued pine boards from Menards link: https://bit.ly/2lJbnhg)
This print is not recommended for most people as it takes a long time for print and will require a lot of filaments. The sizes of brackets are also overkill for shoes as I was able to stand on the rack. It will be a lot cheaper to just purchase one from Walmart or Ikea.
I still need to print the feet, but the rest of the parts fit well without any issue.
Update 7/2/2018
I finished printing and I can confirm that everything fits nicely.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
