Thingiverse
Shoe support (wall mount)
por andy25lion
6.1k
Descargas
5.1k
Likes
11
Makes
I designed this support to be compact and easy to print. Just print a couple of these and attach to a vertical surface (I used double-sided sticky tape) This model should fit most shoes but some scaling might be needed depending on your needs.
F360 model: https://a360.co/2LV794c
Tips:
* If you want to use double-sided tape choose the type that is thicker and has like a soft foams core. I noticed this type of tape does not unstick after holding a lot of weight for some time.
* For heavier shoes I recommend printing in ABS or PETG due to the tendency for PLA to deform permanently after a continuous load for a long time.
F360 model: https://a360.co/2LV794c
Tips:
* If you want to use double-sided tape choose the type that is thicker and has like a soft foams core. I noticed this type of tape does not unstick after holding a lot of weight for some time.
* For heavier shoes I recommend printing in ABS or PETG due to the tendency for PLA to deform permanently after a continuous load for a long time.
andy25lion también publica en
6 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
