shopvac elbows

90° & 45° female/male elbows for your 2½" shop vac hose (known to fit Craftsman 113.177805 8 gallon wet/dry shop vacs and Ridgid).

I designed this for stacking a Home Depot Dustopper cyclone on top of the shop vac as they only supply one elbow in the Dustopper package and I needed two. You may find other uses.

I used PLA with 15% infill and 0.2mm SPEED layer height.
No support needed. 0.3MM layer height works fine and is much quicker, just not as pretty.

Trivia: The taper is half angle is 1° and male diameter starts at 57.7mm