Thingiverse
shopvac nozzle mount
by zanderk
30
Downloads
11
Likes
0
Makes
Mounts for your extra shop vac nozzles. These fit Craftsman 113.177805 8 gallon wet/dry shop vacs and, I think, most 2½" hose shop vacs (such as Ridgid).
The mount mounts with three #6 flat head screws.
I used PLA with 20% infill and 0.3mm layer height.
No support needed.
Trivia: The taper angle is 1.5° and starts at diameter 57.7mm (the small end) and the taper is 30mm long (with 12mm of straight shank (58.7474mm, 2.31")).
Update: I experienced the same issue as noted in the remix "Shopvac Nozzle Mount (with extra supports)" so I've added some extra material around the point of failure (a chamfer around the inside bottom edge). Not as beefy as the remix but hopefully it will suffice.
The mount mounts with three #6 flat head screws.
I used PLA with 20% infill and 0.3mm layer height.
No support needed.
Trivia: The taper angle is 1.5° and starts at diameter 57.7mm (the small end) and the taper is 30mm long (with 12mm of straight shank (58.7474mm, 2.31")).
Update: I experienced the same issue as noted in the remix "Shopvac Nozzle Mount (with extra supports)" so I've added some extra material around the point of failure (a chamfer around the inside bottom edge). Not as beefy as the remix but hopefully it will suffice.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
