Thingiverse
Shopvac replacement nozzle
door The_Herder
2
Downloads
0
Likes
0
Makes
Replacement hose nozzle for ShopVacs. This was modeled after a crafts man, but should work fine for other ~54mm(2.125in) in diameter ShopVac hoses.
I preferred printing this nozzle side down so the mid section formed flat without supports. This will allow the hose to fit snug to the end-stop in the middle of the nozzle while also not needing supports or any clean up. ymmv
I preferred printing this nozzle side down so the mid section formed flat without supports. This will allow the hose to fit snug to the end-stop in the middle of the nozzle while also not needing supports or any clean up. ymmv
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!