MakerWorld
Sport & Outdoors
Model downloaden
Shotgun shell holder v2
359
Downloads
268
Likes
121
Makes
Shotgun 12GA shell holder, 8rounds capacity.You need also8 magnets 9x2mm glued in upper part (i tried it without magnets on shooting range, and it was ok, but it is better to gle magnets to be sure that shells will be in proper place);4 bolts M6x70 with nutsspring 8x80 - i cutted it to about 2cm-3cm piecesIt is good to spray a little ptfe lube on places, when shell holders slides on chassis.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
